CNC lathe is a kind of equipment that integrates various technologies such as machine, electricity, liquid, gas and microelectronics. After the failure occurs, there are certain difficulties in troubleshooting and maintenance. This requires the operator to take precautions when using CNC lathes to process products, thereby reducing the chance of failure and improving the utilization of CNC lathes.
In accordance with the technical requirements of the installation environment of the CNC lathe, the machine tool is placed in a relatively dust-free, constant temperature, constant humidity location. Although it is very difficult to do, try to create a sword, try to be close to such a use environment.
1)WEAR PROPER APPAREL
No loose clothing, gloves, neckties, rings bracelets, or jewelry to get caught in moving parts. Non-slip footwear is recommended. Wear protective hair covering to contain long hair.
2)MAINTAIN TOOLS IN TOP CONDITION
Keep tools sharp and clean for best and safest performance. Follow instructions for lubricating and changing accessories.
3)DISCONNECT TOOLS FROM POWER SOURCE.
Before serving and when changing accessories such as blades, bit cutters or when mounting and remounting motor.
4)AVOID ACCIDENT STARTING.
Make sure switch is in “OFF” position before plugging in a cord.
5)USE RECOMMENDED ACCESSORIES.
Consult the owner’s manual for recommended accessories. Use of improper accessories may be hazardous.
6)NEVER LEAVE TOOL RUNNING UNATTENDED
Don’t leave tool until it comes to a full stop. The operation of any power tool may result in some objects being thrown into the eyes, which can result in severe eyes damage. Always wear safety glasses or eye shields before using your lathe. We recommended a wide vision safety mask or standard safety glasses.
Safety is a combination of operator’s common sense and alertness at all times when the lathe is being used. Study these safety rules and general safety rules before operating and retain for further use.
1)Never attempt any operation or adjustment if the procedure is not understood.
2)Keep fingers away from revolving parts and cutting tools while in operation.
3)Never perform an abnormal or little used operation without study and use of adequate slipper blocks, jigs stops, and fixtures, etc.
4)Do not remove drive cover while the machine is in operation.
5)Always remove chuck key, even when the machine is not in operation.
6)Do not attempt to adjust or remove tools when in operation.
7)Never use in an explosive atmosphere or where a spark could ignite a fire.